Materials: Fjellse Full-size Bed Frame, Sutlan Florvag, wood screws, 4
lag bolts, wood glue
Description: The whole idea for this project stemmed from our need to turn our guest room into more than just a place that gets used by friends and family 2 weeks a year. Most of our visitors are couples, so we needed more than just a standard twin daybed, the width of the space was also just a bit too small to fit a queen size bed. Enter the idea of the pull out daybed.
We started with a Fjellse bed frame and took meticulous measurements and sketched out plans to have the bed pull apart to expand to a full size bed. Using almost every single piece of wood that came with the bed and a 2X6 piece of wood, we constructed the frame. The lag bolds and a few extra wood screws were the only additions.
The middle support was cannibalized to make laminated legs (attractive and sturdy) for the frame that was made out of the headboard, baseboard, and the rails that were cut in half. We narrowed the spacing of the rails that attached to the headboard,before eventually constructed a sliding bed base out of hardwood slats (DO NOT USE PINE OR THE BED BASES SOLD AT IKEA).
Once the bed was slats were attached to the appropriate sliding side, I took some old fence boards that we cut to size to make a flat headboard, and then upholstered it using batting, DIY fabric buttons, a linen-like material, and our handy dandy staple gun.
After that, we took a serrated bread knife to an ikea foam double mattress, cut it in half before putting its back in its outer covering, and fold it in half as need for a full bed, or a day bed!
The bed fits the space perfectly and is rather comfy too!
~ Lynn, Seattle, WA
No comments:
Post a Comment