P�llbo 022

Materials: Materials: SOLSTA P�LLBO, mdf, scrap wood.

Description: In our small living room, we could use extra storage space. We also needed spare chairs, for the occasional extended family dinner, at our extendable table. Inspired by the Laphoeff 022 design, I hacked our existing three P�llbo�s to add storage and make them adjustable in height.

We now have extra storage and 3 instant extra table chairs, at little cost. I added felt on the bottom of the mdf boxes, so now they are easy to slide around.

Here's how I did it:
1. Cut off the "feet" of the P�llbo. Dissassemble P�llbo, and attach two wooden slats (of equal thickness as the vertical slats) horizontally (screws and glue), between the vertical slats, on two opposing insides of the P�llbo.
2. Make a rectangular box from mdf (or timber board).
3. Reassemble P�llbo.
4. Fill mdf box with stuff.
5. Slide P�llbo over box.

Depending on how you slide the P�llbo over the mdf box, it will slide almost all the way over to its original height, or (when rotated 90 degrees) the horizontal slats will stop it from doing so (and rest on top of the short edges of the mdf box), making it the height of a table chair.

Make sure the distance between the top of P�llbo (not counting the cushion) and the bottom of the horizontal slats is equal to the added height you want for the P�llbo in high position. I made the mdf boxes 30 cm high, so in 'low' position the P�llbo's still have their original height, with the box sticking out just as much as the original feet.

The key is to make the mdf box rectangular, so that it fits the inside of the P�llbo from side to side in one direction, but only from slat tot slat in the other direction. This way, some room is left (the depth of one slat on each side) in one direction between the sides of the P�llbo and the mdf box. One problem is that the distance between the slats in the P�llbo is unequal (29 cm one way, 30 cm the other way).

I went the difficult route, and made the boxes 30x35 cm. This meant I had to remove a strip of 0,5 cm from the vertical slats (as you can see in the photo), which was a lot of work, even with a circular saw. This way I wanted to create some extra support in the high position, since you get a small nook in the vertical slats that also rests on the mdf box. I think sticking to the smallest length (29 cm) would have worked just as well, and saved a lot of work.

For an even easier build, using the Pr�nt box (27x35 cm, 27 cm high) would probably work just as well, even though it is a little lower. Then all it takes is adding the horizontal supports at the right height. Adding two extra horizontal slats of 3 cm would bring this up to the normal height of P�llbo again.

~ G.V.M., The Netherlands