Tuesday 9 November 2010

Turn Jonisk table lamp into pendant


Materials: Jonisk table lamp, drill, scissors, wire stripper, screwdriver

Description: Open the lamp by screwing off the bottom plate
Cut off the wire close to the dimmer
Remove the wire from the hole on the side
Drill a hole right in the middle of the aluminum bottom plate (drill bit nr. 6)
Put the strain relief on the wire
Pull the wire through the hole
Screw the bottom plate back on
Ready!
If you need a longer wire use an electric cable connector block under the bottom plate

~ Marianne, Netherlands

No comments:

Post a Comment